Filter
Top Products
Hardware
Installing the LCS60
Connection through Modems
To connect an asynchronous terminal or PC to the LCS60 for use as a system con-
sole by means of modems, refer to Figure 2-5 and follow the steps below:
1 . Option Serial Port 1 to emulate DTE operation. (Refer to the section Serial
Port Optioning earlier in this chapter.)
2 . Connect the LCS60 rear panel connector labeled "Serial Port 1" to an asyn-
chronous terminal by means of modems using straight-through RS-232
cabling. Modems must operate asynchronously at 9600 bps.
3 . Power up the system console and set options as directed in Table 2-4.
4 . Continue with the Connecting Fiber Interface section.
Figure 2-5: System Console Connections – through Modems
Asynchronous
Terminal
Modem
Modem
DTE
Console
Port
LCS60
Connection through StarKeeper II NMS
For the StarKeeper II NMS connection (Figure 2-6), follow the steps below:
1 . Serial Port 1 should be optioned to emulate DCE operation. This is the
default; therefore, if you haven’t changed anything there will be no need
to change the option.
Issue 3 2-17