Filter
Top Products
Error Messages
Outgoing Call Error Messages
Splice failed
The connection endpoints could not be successfully spliced together.
Transmit window too big
The call could not be completed because the transmit window size is too
big.
Trunk busy
The call could not be completed because a trunk in the call path is busy.
Trunk configuration mismatch. Call Network Administrator
The call was rejected because a trunk in the call path is not properly con-
figured. Contact the data switch Network Administrator.
Trunk not answering
The call could not be completed because a trunk in the call path is not in
service.
Unsupported baud rate
The requested baud rate is not supported by the autodialer.
Urp error
The call could not be completed because of an internal protocol error.
Vlp to dial error
The call could not be completed because an error occurred converting vlp
format into a dialstring.
Incoming Error Messages
The following error messages may be seen on the user’s PC when he/she
attempts to start up a SLIP session and the session is refused.
Issue 3 C-9