Filter
Top Products
Administration
Network Access Password Option
# useradd -u444 nap
# passwd nap
New password: password
Re-enter new password: password
#
Note: The password will not echo on the screen.
The Network Access Password user ID parameters (e.g., group, uid, etc.) can be
modified with the usermod command.
An example of the telnet command (with the password option set) is shown in
Screen 8-17.
Screen 8-17: TCP-to-Async Gateway with Network Access Password
$ telnet 154.12.21.5
Trying 154.12.21.5 ...
Connected to 154.12.21.5.
Character mode is enabled.
Escape character is ’~’.
Notice from LCS60(morse)...
The following editing characters are valid during input at prompts:
-- An ASCII "backspace" erases the last character typed,
-- An ASCII "@" deletes the entire input line.
Network Access Password: enter password
Notice from LCS60(morse)...
The following editing characters are valid during input at prompts:
-- An ASCII "backspace" erases the last character typed,
-- An ASCII "@" deletes the entire input line.
morse LCS60 DESTINATION: mlkway/earth/watson
login:
Note: The Network Access Password prompt appears only if the password
option is set. Echoing is turned off when the password is entered.
Issue 3 8-39