Filter
Top Products
User Information
PPP Service Examples
Note: Be aware that baud rates are dictated by the application, serial drivers
installed, and the version of the PC UART.
InterPPP
Note: InterPPP II is different from InterPPP. Refer to the user documentation
for specific details.
The InterPPP software requires minimal Mac configuration for AppleTalk or IP
over PPP.
Note: Make sure MacTCP is installed in the Control Panels folder. MacTCP
should come with the InterPPP package. TCP/IP should be selected
under the MacTCP for the initial connection.
Note: Remember to reselect PPP for the next PPP session.
Connection
To establish the PPP connection, perform the following steps:
1 . From the Network Control Panel of the Control Panels folder select the
AppleTalk/PPP icon. (Refer to Figure F-5.) This tells the AppleTalk
software to use the serial port instead of the built in LAN port.
2 . Launch the InterPPP application.
3 . Under File, choose New or Open CCL Script; create/edit and save the
script.
4 . Under Configure, select Modem (refer to Figure F-6):
— Choose Port; select Modem Port
— Choose Modem; select your CCL script
— Choose After Connect: select StartPPP; then close the window.
5 . Under Configure; select PPP: choose the PPP settings (Figure F-6); then
close the window.
F-14 Issue 3