Filter
Top Products
LCS60 Software
Initial Setup
WARNING: "lcsadm" configuration is already in progress. Continuing can
cause catastrophic results!
Do you want to continue? [y/n]
Step 7 The lcsadm interface takes you into a hierarchical system of
directories and commands. (For example, Screen 3-1.)
Screen 3-1: LCS60 Top Directory
sysV68:Top> Return
Commands may be abbreviated. Commands are:
config/ help manager/ ports/ quit
service/ session/ start stop ^
!
Note: The machine name (shown in Screen 3-1 as sysV68) appears at the
beginning of the Top> prompt. The sysV68 will be replaced by the node
name you configure for your LCS60 after you exit and then re-enter the
lcsadm interface (in the example that follows the prompt would become
morse:Top>). The screen displays in this document, however, omit the
machine name to avoid confusion.
Note: The directories are followed by a slash "/" in the screen display.
Step 8 To navigate through the directories, enter the name of the directory
you wish to access (top, session, ports, service, manager, config). To see
the contents of a directory, use the ls command or the Return key.
Step 9 Enter the Config directory by typing config at the Top> prompt.
Note: Command and directory names can be abbreviated by typing a unique
string of the beginning characters of the command (e.g., the command
backup can be accessed by typing b at the Top>Config># prompt).
Issue 3 3-5