Filter
Top Products
Maintenance
VMEDKHS Diagnostics
2 . Check the VMEDKHS board:
Log into the system console and enter stop dkhost from the lcsadm
interface
Quit the lcsadm interface and enter dkdiag -a -n5 -i0 from the root
prompt
Verify that the diagnostic is completed successfully
If a failure occurs, reboot the system; if the error message occurs
again, check the CPM-HS board in the data switch node.
3 . Check the CPM-HS board:
On the data switch console, conduct the dialogue shown in Screen 9-7.
Screen 9-7: Example diag cpm for CPM-HS Module
CC0> rem cpm 11
CC0> diag cpm
MODULE ADDRESS: 11
TEST TYPE [command_logic, module_reset,
local_loop, remote_loop]: command_logic
90-08-18 13:46:56 NODE=NODENAME
M diagnose cpm 11 command_logic
Command Logic Test Successful
CC0> diag cpm 11
TEST TYPE [command_logic, module_reset,
local_loop, remote_loop]: module_reset
90-08-18 13:47:40 NODE=NODENAME
M diagnose cpm 11 module_reset
Module Reset Test Successful
CC0> diag cpm 11
TEST TYPE [command_logic, module_reset,
local_loop, remote_loop]: local_loop
Replace the fiber optic link connection on the paddle board
with a loop-around connector.
9-26 Issue 3