Filter
Top Products
LCS60 Software
Initial Setup
*** This step allows the LCS60 Administrator to enter the software key for this
*** LCS60 in order to activate the appropriate software features.
SOFTWARE KEY CONFIGURATION PARAMETERS
1. Display LCS60 Machine ID
2. Enter Software Certificate and Software Key
3. Display Software Certificate and Software Key
Enter Menu Selection
[ Type q to QUIT or ? for HELP ]
==> 1
+-------------------------+
| |
| LCS60 ID: XXXXXXXX |
| |
+-------------------------+
SOFTWARE KEY CONFIGURATION PARAMETERS
1. Display LCS60 Machine ID
2. Enter Software Certificate and Software Key
3. Display Software Certificate and Software Key
Enter Menu Selection
[ Type q to quit or ? for help ]
==> 2
In order to complete the software key configuration, you must:
Display the LCS60 machine ID as shown above and enter this number on
your LCS60 Network Interface for Ethernet Software Certificate
Call 1-800-WE2CARE for the software key; you will need to supply the
information requested on your LCS60 Network Interface for Ethernet Software
Certificate.
Note: If you do not receive the software key immediately (for example, if you
call the 800 number after hours), you may enter a q on the screen above
to continue with configuration. You can enter the software key using the
lcsadm config softwarekey command at any time, however, you must
enter the software key before you can successfully activate the services
you configure. (Refer to Chapter 8 for the softwarekey command.)
Issue 3 3-7