Filter
Top Products
Hardware
Installing the LCS60
2 . Connect the LCS60 rear panel connector labeled "Serial Port 1" to an asyn-
chronous port on the data switch using a straight-through connection
(D8AH connector); connect the 25-pin end to the LCS60.
3 . Configure the asynchronous port on the data switch according to Table
2-4 as a receiving group. Conduct the dialogue shown in Screen 2-1 (TY-
12) or Screen 2-2 (MSM) on the data switch console to:
a . Configure a group on the data switch network for the asynchronous port
connected to the LCS60
b . Configure a name pointing to this group which can be used to access the
LCS60 console port.
Refer to the appropriate Lucent Technologies data switch Node Reference
Guide for complete instructions.
4 . Restore the asynchronous port and name to service.
5 . Log on to StarKeeper II NMS; execute dkcu to the call address created for
the LCS60 console. Maintain proper security precautions to guard against
unauthorized or accidental usage.
6 . Continue with the Connecting Fiber Interface section.
Figure 2-6: System Console Connections – through StarKeeper II NMS
Asynchronous
Terminal
StarKeeper
II NMS
Data
Switch
CPM-HS
Asynchronous
Port
DCE
Console
Port
LCS60
2-18 Issue 3