Filter
Top Products
Hardware
Installing the LCS60
Power-Down Procedures
Only a user logged on as root may shut the system down at the system console.
When logged on as a user, log off and log back on as root (refer to Chapter 8).
(As shipped, the root password is the Return key.) At the root prompt (#),
enter:
/etc/shutdown -g0 -y -i0
The on/off switch can be used to halt the system only when you receive the mes-
sage stating the system is secured for powering down.
Caution: Use the correct procedure to power down the system. Do not use
the Reset button, the on/off system power switch, or pull the
electrical plug to stop the system or UNIX System file corruption
may result.
Reboot
To reboot the system (rather than shut it down), use the command:
/etc/shutdown -g0 -y -i6
This will shutdown the system and then reboot it. The reboot sequence ends
with the Console Login: prompt.
Verify LCS60 Console Connection
To verify the console connection, perform the following:
1 . Power-up the LCS60 and verify that communication with the console has
been established. The console should display diagnostic text followed by
the Console Login: prompt.
2 . If the above information is not displayed on the console after powering-up
the LCS60, check the following for your connection:
Direct – console optioning and cabling
Through the Data Switch – console and LCS60 connections to the
data switch network and the related data switch configuration
Issue 3 2-27