Filter
Top Products
LCS60 Software
Introduction
Specific Services
The instructions in this chapter describe the configuration of some of the avail-
able services on the LCS60. For details of configuring a specific service, refer to
the appropriate chapter: PPP (Chapter 4), SLIP (Chapter 5), ARAP (Chapter 6),
gateway services (Chapter 7).
Initial Setup
The initsetup command allows you to configure the basic LCS60 as shown in Fig-
ure 3-2. After completing the steps in initsetup you must continue with the con-
figuration required for your LCS60 (refer to the sections Configure Protocols and
Gateway Services and Configure Default Route, DNS, and SNMP in this chapter and
to Chapters 4 through 7).
Note: Fill-in the "Installer, Administrator, and Hardware Site" information on
your LCS60 Network Interface for Ethernet Software Certificate (included in
your LCS60 package). Keep this certificate handy; you will need it once
you enter initsetup. You will not be able to complete all the steps in
initsetup without this certificate.
Perform the following steps to power up the LCS60 and configure the basic
features (nodename, datetime, softwarekey).
Step 1 Flip the LCS60 rear power switch to the on position.
Step 2 Notice the power-on messages on the screen, and wait for the Con-
sole Login: prompt. This may take 1–2 minutes.
Step 3 Enter root as the login name.
Step 4 As shipped the root login uses a carriage return for the password.
Enter Return at the password prompt; you are now logged in to
the LCS60 as root.
Issue 3 3-3