Filter
Top Products
LCS60 Software
Introduction
Verify that the following procedures have been followed:
1 . The LCS60 is securely mounted as described in Chapter 2.
2 . There is a fiber pair connection between the LCS60 and the CPM-HS
module in the data switch node.
3 . A grounded power cord is attached to the power input jack on the rear
panel of the LCS60.
4 . An RS-232 connection exists between the rear console port of the LCS60
and one of the following:
Modem
TY-12 port on the data switch node
Directly connected terminal.
Preliminary Configuration Requirements
Before configuring the LCS60, you must have the following information on hand:
nodename of the LCS60
IP and IPX addresses for the ethernet
IPX frame type for ethernet
protocols and services the LCS60 will be using
the number of sessions required for each protocol
the default route
the Domain Name Service (if DNS is to be used)
the SNMP manager (if SNMP is to be used)
IP and IPX addresses for virtual networks (if remote access is to be used)
AppleTalk address and zone name for the AppleTalk virtual network (if
AppleTalk is to be used)
3-2 Issue 3