Filter
Top Products
SLIP
LCS60 Configuration and Connection for SLIP Service
Screen 5-3:
Continued
Enter aliases for morse
Separate each alias with blanks
Hit return if there are no aliases [q to quit]
==>
==> Is morse [154.12] divided into subnets ? [y, n, ?] y
Enter name of subnet to be added
[? for help, q for quit]
==> m-net0
Enter number of mask bits for this subnet
[? for help, q for quit]
==> 8
Entering Ethernet interface 0 morse-e0 [154.12.21.5]
==> Is this correct? [y, n] y
Ethernet interface 0 morse-e0 [154.12.21.5] configured !
Enter Menu Selection
[ ? for help, q to quit, RETURN for menu ]
==> q
NOTE: Changes to the configuration will not take effect until you:
- enter the lcsadm command and then type "stop tcpip" from the
top command directory to stop TCP/IP protocol.
- enter the lcsadm command and then type "start tcpip" from the
top command directory to start TCP/IP protocol.
Top>Config>#
8 . From the Top directory, enter start all.
Note: In order for changes made to IP network number or subnet mask
to take effect, you must first stop and then restart tcpip and
routed.
9 . To complete SLIP configuration, you must configure the client side of the
service. Refer to the documentation included with your client software;
examples of some software packages are given in Appendix F.
To unconfigure SLIP service, stop the service using stop slip, enter maxsessions
at the Top>Config># prompt, and choose option 2 to delete the service.
5-8 Issue 3