Filter
Top Products
EM78P259N/260N
8-Bit Microprocessor with OTP ROM
14 •
Product Specification (V1.2) 05.18.2007
(This specification is subject to change without further notice)
Bit 2 (CMPWE): Comparator wake-up enable bit
0 = Disable Comparator wake-up
1 = Enable Comparator wake-up
When Comparator enters sleep mode, this bit must be set to “Enable.“
Bit 1 (ICWE): Port 5 input change to wake-up status enable bit
0 = Disable Port 5 input change to wake-up status
1 = Enable Port 5 input change to wake-up status
When Port 5 change enters sleep mode, this bit must be set to
“Enable“.
Bit 0: Not implemented, read as ‘0’
6.1.15 RF (Interrupt Status 2 Register)
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
LPWTIF HPWTIF TCCCIF TCCBIF TCCAIF EXIF ICIF TCIF
Note: “ 1 ” means with interrupt request “ 0 ” means no interrupt occurs
RF can be cleared by instruction but cannot be set.
IOCF0 is the relative interrupt mask register.
Reading RF will result to "logic AND" of RF and IOCF0.
Bit 7 (LPWTIF): Internal low-pulse width timer underflow interrupt flag for IR/PWM
function. Reset by software.
Bit 6 (HPWTIF): Internal high-pulse width timer underflow interrupt flag for IR/PWM
function. Reset by software.
Bit 5 (TCCCIF): TCCC overflow interrupt flag. Set when TCCC overflows. Reset by
software.
Bit 4 (TCCBIF): TCCB overflow interrupt flag. Set when TCCC overflows. Reset by
software.
Bit 3 (TCCAIF): TCCA overflow interrupt flag. Set when TCCC overflows. Reset by
software.
Bit 2 (EXIF): External interrupt flag. Set by falling edge on /INT pin. Reset by
software.
Bit 1 (ICIF): Port 5 input status change interrupt flag. Set when Port 5 input
changes. Reset by software.
Bit 0 (TCIF): TCC overflow interrupt flag. Set when TCC overflows. Reset by
software.
6.1.16 R10 ~ R3F
All of these are 8-bit general-purpose registers.