Filter
Top Products
CHAPTER 11
Performing Initial Configuration
•
EX2200 Switch Default Configuration on page 83
•
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 87
•
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 89
EX2200 Switch Default Configuration
Each EX Series switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file for an EX2200 switch configures Ethernet switching and stormcontrol
on all interfaces, configures Power over Ethernet (PoE) on all interfaces of models that
providePoE,andenablestheLLDP,LLDP-MED,and RSTPprotocolsandIGMPsnooping.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. Youcan always revert to the factory default
configuration.SeeRevertingtotheDefaultFactoryConfigurationfortheEXSeriesSwitch.
The following factory default configuration file is for an EX2200 switch with 24 ports, all
of which have PoE capability:
NOTE: Formodels that have more than 24 ports, this default configuration
filehas moreinterfaces. For models without PoE, the poe stanza does not
appear.Allmodelshavefouruplinkportsaslistedbelow,ge-0/1/0toge-0/1/3.
ethernet-switching-options {
storm-control {
interfaceall {
level 50;
}
}
}
protocols{
igmp-snooping {
vlanall;
}
lldp{
interfaceall;
}
83Copyright©2010, JuniperNetworks, Inc.