Filter
Top Products
5. Perform initial configuration of the switch by following instructions in “Connecting
and Configuringan EX Series Switch (CLI Procedure)”on page87 or “Connecting and
Configuring an EX Series Switch (J-WebProcedure)” on page 89.
6. Set the switch’s management options by following the appropriate instructions:
•
Connecting an EX Series Switch to a Network for Out-of-Band Management on
page 74
•
Connecting an EX Series Switch to a Management Console on page 76
Related
Documentation
Rack Requirements for EX2200 Switches on page 39•
• Cabinet Requirements for EX2200 Switches on page 40
• Clearance Requirementsfor Airflow and Hardware MaintenanceforEX2200 Switches
on page 42
Unpacking an EX2200 Switch
The EX2200 switches are shipped in a cardboard carton, secured with foam packing
material. The carton has an accessory compartment and contains the quick start
instructions.
CAUTION: EX2200 switches are maximally protected inside the shipping
carton. Do not unpack the switches until you are ready to begin installation.
To unpack the switch:
1. Open the carton.
2. Pull out the packing material holding the switch in place.
3. Verify theparts receivedagainstthe inventoryon the labelattachedtothe cartonand
listed in Table 22 on page 52.
4. Save the shipping carton and packing materials in case you need to move or ship the
switch later.
Table 22: Inventory of Components Provided with an EX2200 Switch
QuantityComponent
1Switchwith built-in power supply
1ACpowercordappropriate foryourgeographical location
1Powercordretainerclip
2Mounting brackets
Copyright ©2010,Juniper Networks,Inc.52
CompleteHardwareGuide forEX2200 EthernetSwitches