Filter
Top Products
Requirements for Mounting an EX2200 Switch on a Desktop or Wall
You can install the switchon a desktop or wall. When choosing a location, allowat least
6 in. (15.2 cm) of clearance between the front and back of the chassis and adjacent
equipment or walls.
Ensure that the wall onto which the switch is installed is stable and securely supported.
If you are mounting the switch in sheetrock (wall board with a gypsum plaster core) or
in wall board not backed by wall studs, use hollow wall anchors capable of supporting
the combined weight of two fully loaded chassis. Insert the screws into wall studs
wherever possible to provide added support for the chassis.
Use the wall-mount kit from Juniper Networks to mount the switch on a wall. The
wall-mount kit is not part of the standard package and needs to be ordered separately.
Related
Documentation
Clearance Requirements forAirflow and HardwareMaintenancefor EX2200 Switches
on page 42
•
• Wall-Mounting Warnings for EX2200 Switches on page 134
• Mounting an EX2200 Switch on a Desk or Other Level Surface on page 54
• Mounting an EX2200 Switch on a Wall on page 61
Clearance Requirements for Airflow and Hardware Maintenance for EX2200 Switches
When planning the site for installing an EX2200 switch, you must allow sufficient
clearance around the installed switch (see Figure 10 on page 42).
Figure10:ClearanceRequirementsforAirflowandHardwareMaintenance
for EX2200 Switches
g027009
Mounting bracket
6" (15.2 cm)
for airflow
Rear of chassis
Front of chassis
17.5"
44.5 cm
10.5"
(26.7 cm)
Clearance
required for
maintenance
Clearance required
for maintenance
24" (61 cm)
6" (15.2 cm)
6" (15.2 cm)
for airflow
19"
(48.2 cm)
The power cord retainer clips extend out of the rear of the chassis by 3 in.
•
Allow at least 6 in. (15.2 cm) of clearance on the side between devices that have fans
or blowers installed. Allow 2.8 in. (7 cm) between the side of the chassis and any
Copyright ©2010,Juniper Networks,Inc.42
CompleteHardwareGuide forEX2200 EthernetSwitches