Filter
Top Products
WARNING: Donot leave a fiber-optic transceiver uncovered exceptwhen
inserting or removing a cable. The rubber safety cap keeps the port clean
and preventsaccidental exposure to laser light.
3. If the port in which you want to install the transceiver is covered with a dust cover,
remove the dust cover and save it in case you need to cover the port later. If you are
hot-swappingatransceiver,waitforatleast10secondsafterremovingthetransceiver
from the port before installing a transceiver.
4. Using both hands, carefully place the transceiver in the empty port. The connectors
must face the switch chassis.
CAUTION: Before you slide the transceiver into the port, ensure the
transceiver is aligned correctly. Misalignment might cause the pins to
bend, making the transceiver unusable.
5. Slide the transceiver in gently until it is fully seated.
6. Remove the rubber safety cap when you are ready to connect the cable to the
transceiver.
WARNING: Donot look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceiversand fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
Figure 24: Installing a Transceiver in an EX Series Switch
Related
Documentation
• Removing a Transceiver from an EX Series Switch on page 95
• Connecting a Fiber-Optic Cable to an EX Series Switch on page 81
• Optical Interface Support in EX2200 Switches on page 22
• Optical Interface Support in EX3200 Switches
• Optical Interface Support in EX4200 Switches
• Optical Interface Support in EX4500 Switches
• Optical Interface Support in EX8200 Switches
Copyright ©2010,Juniper Networks,Inc.66
CompleteHardwareGuide forEX2200 EthernetSwitches