Filter
Top Products
NOTE: When Telnet is enabled, you will not be able to login to an EX
Series switch through Telnet using root credentials. Root loginis allowed
only for SSH access.
6. Use the Management Options page to select the management scenario:
NOTE: OnEX4500 and EX8200 switches, only the out-of-band
management option is available.
•
Configurein-bandmanagement.Inthis scenarioyouhavethefollowingtwooptions:
•
Use the default VLAN.
•
Create a new VLAN—If you select this option, you are prompted to specify the
VLAN name, VLAN ID, management IP address, and default gateway. Select the
ports that must be part of this VLAN.
•
Configure out-of-band management. Specify the IP address and gateway of the
management interface. Use this IP address to connect to the switch.
7. Specify the SNMP Read Community, Location, and Contact to configure SNMP
parameters. These parameters are optional.
8. Specify the system date and time. Select the time zone from the list. These options
are optional.
The configured parameters are displayed. Enter yes to commit the configuration.
The configuration is committed as the active configuration for the switch. Youcan now
log in with the CLI or the J-Web interface to continue configuring the switch. If you use
the J-Web interface to continue configuring the switch, the Web session is redirected to
thenewmanagementIPaddress.Iftheconnectioncannotbemade,theJ-Webinterface
displays instructions for starting a J-Web session.
Related
Documentation
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 89•
• Installing and Connecting an EX2200 Switch on page 51
• Installing and Connecting an EX3200 Switch
• Installing and Connecting an EX4200 Switch
• Installing and Connecting an EX4500 Switch
• Installing and Connecting an EX8208 Switch
• Installing and Connecting an EX8216 Switch
Copyright ©2010,Juniper Networks,Inc.88
CompleteHardwareGuide forEX2200 EthernetSwitches