Filter
Top Products
WARNING: Donot leave a fiber-optic transceiver uncovered exceptwhen
inserting or removing a cable. The rubber safety cap keeps the port clean
and preventsaccidental exposure to laser light.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius.Anarcsmallerthanafewinchesindiametercandamagethecables
and cause problems that are difficult to diagnose.
3. Remove the cable connected to the transceiver (see “Disconnecting a Fiber-Optic
Cable from an EX Series Switch” on page 97). Cover the transceiver and the end of
each fiber-optic cable connector with a rubber safety cap immediately after
disconnecting the fiber-optic cables.
4. Using your fingers, pull the ejector lever on the transceiver to unlock the transceiver.
CAUTION: Beforeremovingthetransceiver,makesureyouopentheejector
lever completely until you hear it click. This prevents damage to the
transceiver.
5. Using the needlenose pliers, pull the ejector lever out from the transceiver.
6. Grasp the transceiver ejector lever and gently slide the transceiver approximately
0.5 in. (1.3 cm) straight out of the port.
CAUTION: To avoid electrostatic discharge (ESD) damage to the
transceiver,do not touchthe connectorpins at the end of the transceiver.
7. Usingyourfingers,graspthebody ofthe transceiverandpull itstraightoutof theport.
8. Place the transceiver in the antistatic bag or on the antistatic mat placed on a flat,
stable surface.
9. Place the dust cover over the empty port.
Figure 37: Removing a Transceiver from an EX Series Switch
Copyright ©2010,Juniper Networks,Inc.96
CompleteHardwareGuide forEX2200 EthernetSwitches