Filter
Top Products
To mount the switch on four posts in a rack:
1. Attachthe frontbrackets(eitherthe flushor the 2-in.-recessbrackets)tothe side-rail
bracketsusing six 4-40 flat-head Phillips mounting screws.See Figure 17on page 59.
Figure 17: Attaching the Front Bracket to the Side-Rail Bracket
2. Place the switch on a flat, stable surface.
3. Align the side-rail brackets along the side panels of the switch chassis. Align the two
holes in the rear of the side-rail brackets with the two holes on the rear of the side
panel.
4. Insert 4x6-mm Phillips flat-head mounting screws into the two aligned holes and
tighten the screws. Ensure that the two holes in the rear of the side-rail brackets are
aligned with the remaining two holes in the side panel. See Figure 18 on page 59.
Figure 18: Attaching the Side-Rail Bracket to the Switch Chassis
g027017
5. Insert the 4x6-mm Phillips flat-head mounting screws into the remaining two holes
in the side-rail brackets and tighten the screws.
6. Have one person grasp both sides of the switch, lift the switch, and position it in the
rack, aligning the side-rail bracket holes with the threaded holes in the front post of
the rack. Align the bottom holein both themounting bracketswith a holein eachrack
rail, making sure the chassis is level. See Figure 19 on page 60.
59Copyright©2010,Juniper Networks,Inc.
Chapter8:Installing theSwitch