Filter
Top Products
Specifying Management Settings
13
Scanner Mode 13-45
2 Touch [Mode Selection], and
then use the keypad to type
in the mode number.
3 Touch [Bit Selection], and
then touch [←] and [→] to
move the cursor below the
bit to be changed.
4 Use the keypad to specify either “0” or “1” for the bit, and then touch
[Enter].
❍ To change other modes, repeat the procedure from step 2.
5 Continue touching [Enter] to return to the Utility screen, and then touch
[Exit] to return to the standby screen (initial screen).
Specifying functions with [HEX Selection]
1 Touch [Admin. 2], and then
touch [Soft SW Set].
❍ Refer to “Displaying the
Administrator
Management screen” on
page 13-11