Filter
Top Products
ProSecure Unified Threat Management (UTM) Appliance Reference Manual
B-16 Network Planning for Dual WAN Ports (Dual-WAN Port Models Only)
v1.0, January 2010
VPN Telecommuter (Client-to-Gateway Through a NAT Router)
The following situations exemplify the requirements for a remote PC client connected to the
Internet with a dynamic IP address through a NAT router to establish a VPN tunnel with a gateway
VPN firewall such as an UTM at the company office:
• Single gateway WAN port
• Redundant dual gateway WAN ports for increased reliability (before and after rollover)
• Dual gateway WAN ports for load balancing
VPN Telecommuter: Single Gateway WAN Port (Reference Case)
In a single WAN port gateway configuration, the remote PC client at the NAT router initiates the
VPN tunnel because the IP address of the remote NAT router is not known in advance. The
gateway WAN port must act as the responder.
The IP address of the gateway WAN port can be either fixed or dynamic. If the IP address is
dynamic, you must use a FQDN. If the IP address is fixed, a FQDN is optional.
Note: The telecommuter case presumes the home office has a dynamic IP address and
NAT router.
Figure B-17