Filter
Top Products
ProSecure Unified Threat Management (UTM) Appliance Reference Manual
2-24 Using the Setup Wizard to Provision the UTM in Your Network
v1.0, January 2010
Setup Wizard Step 9 of 10: Signatures & Engine
Enter the settings as explained in Table 2-9 on page 2-25, then click Next to go the following
screen.
Figure 2-15
Note: After you have completed the steps in the Setup Wizard, you can make changes to
the signatures and engine settings by selecting Administration > System Update
> Signatures and Engine. For more information about these settings, see
“Updating the Scan Signatures and Scan Engine Firmware” on page 10-21.