Filter
Top Products
ProSecure Unified Threat Management (UTM) Appliance Reference Manual
Using the Setup Wizard to Provision the UTM in Your Network 2-23
v1.0, January 2010
Setup Wizard Step 8 of 10: Email Notification
Enter the settings as explained in Table 2-8, then click Next to go the following screen.
Figure 2-14
Note: After you have completed the steps in the Setup Wizard, you can make changes to
the administrator email notification settings by selecting Network Config > Email
Notification. For more information about these settings, see
“Configuring the E-mail Notification Server” on page 11-5.
Table 2-8. Setup Wizard Step 8: Administrator Email Notification Settings
Setting Description (or Subfield and Description)
Administrator Email Notification Settings
Show as mail sender A descriptive name of the sender for e-mail identification purposes. For
example, enter UTM_Notifications@netgear.com.
SMTP server The IP address and port number or Internet name and port number of your
ISP’s outgoing e-mail SMTP server. The default port number is 25.
Note: If you leave this field blank, the UTM cannot send e-mail notifications.
This server requires
authentication
If the SMTP server requires authentication, select the This server requires
authentication checkbox and enter the following settings:
User name The user name for SMTP server authentication.
Password The password for SMTP server authentication.
Send notifications to The email address to which the notifications should be sent. Typically, this is the
e-mail address of the administrator.