Filter
Top Products
Page: 82
Service Guide OJ2010
Chapter 3 Maintenance and Disassembly
3.2.25 Pick Roll Hub, Shaft, and Envelope Bucklers
1. Remove the preliminary items. . . . . . . . . . (3.2.01 )
2. Remove the front cover. . . . . . . . . . . . . . . . (3.2.12
)
3. Remove the rear cover. . . . . . . . . . . . . . . . (3.2.30
)
4. Remove the paper load door. . . . . . . . . . (3.2.24
)
5. Remove the manual insert tray. . . . . . . . . (3.2.20
)
6. Slide the left paper guide (1) to the right.
7. Remove the E-ring (2) from the left side of the pick roll shaft (3).
8. Pull the pick roll shaft out to the left and remove the pick roll shaft, hubs (4), envelope bucklers (5),
spacer (6),
and pick roll clutch spring (7).
NOTE:
Installation
Be sure that the pick roll hubs are in the slots at the bottom of the paper guides and that the rolls
are centered on the pick pads.
P/N 50409801 Assembly: Pick Roll Hub
RSPL
B.2.08
P/N 51113601 Shaft: Pick Roll & Paper Load
RSPL
B.2.08
P/N 58236901 Packet: Envelope Buckler Parts
RSPL
B.2.08