Filter
Top Products
Page: 25
Service Guide OJ2010
Chapter 1 Product Specifications
Labels
Notes:
The page size for labels is limited to letter and A4.
For best results, DO NOT use labels with a slick backing material.
For best results, DO NOT print within 0.04 inches (1 millimeter) of the die cut.
Acrylic-based labels are preferred.
Adhesive
MUST NOT
extend to within 0.04 inches (1 millimeter) of the edge of the label, come between
the die cuts of the labels, or come in contact with any part of the printer. Labels that do not meet these
guidelines may damage the printer.
Use full label sheets. Partial sheets (with areas exposed by missing labels) may allow labels to peel off
during printing, causing a paper jam.
The label sheet and adhesive must not melt, release hazardous gases, or allow the cover sheet to come
off when the label sheet is exposed to the internal operating temperature or the ink of the unit.
If the unit is powered
OFF
or disconnected while labels are being printed, remove the labels manually,
using the paper release lever, before the unit is powered
ON
. This will prevent labels from peeling off of
the carrier (backing) and sticking to the inside of the unit.
Determine the suitability of labels before ordering or printing large quantities.
Item
Feed Method Type Specifications
Letter Size Auto 8.5 x 11 inches (216 x 279
millimeters)
Manual 8.5 x 11 inches (216 x 279
millimeters)
A4 Size Auto 8.3 x 11.7 inches (210 x 297
millimeters)
Manual 8.3 x 11.7 inches (210 x 297
millimeters)
Basic Weight Auto Paper 32 to 40 lb. (120 to 150 g/m2)
(Substance) Polyester 59 lb. (220 g/m2)
Vinyl 53 lb. (200 g/m2)