Filter
Top Products
Page: 143
Service Guide OJ2010
Chapter 4 Failure and Repair Analysis
4.8.06 Initialize Error Log
This test allows you to track new errors.
Use this procedure to reset the error log to zero.
The error log is especially helpful in diagnosing intermittent or difficult problems.
1. Power
OFF
the printer.
2. Move the two pin jumper on connector J13 of the system board to the pin position shown below.
3. Place a piece of paper in the manual paper feed slot before powering on the printer.
This opens the paper sensor.
The paper sensor must be open to start this procedure.
4. Power
ON
the printer.
5. The test will start.
6. To stop the test, power
OFF
the printer or unplug the printer.
7. Return the jumper to its original pin position.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)