Filter
Top Products
5. Check the encoder strip for wear and dirt.
6. Check the printhead cable.
A. Be sure that connector J4 is fully seated.
B. Check the cable for damage.
7. Check the encoder strip, the printhead cable, the encoder card, and the system board.
Perform the Encoder Sensor Test. Refer to Section 4.8 of this Service Handbook .
If you cannot enter the test, replace the system board.
8. Check the maintenance station.
A problem with the maintenance station can cause carrier movement problems at the right margin.
Perform the Maintenance Station Service Check. Refer to RAP 03 of this Service Handbook .
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)