Filter
Top Products
3. Installing the CPX-1000 1000-A2-GN22-00
3-22 February 2003
Installing
Additional Cards
To install cards that are not yet installed in the CPX:
Step 1 Put on an antistatic wrist strap, and plug the other end of that strap
into the ESD ground jack in front (or back) of the CPX shelf.
Step 2 Slide each module into the cage slot until its ejector handles engage
the retention bars at the top and bottom of the CPX.
Step 3 Tighten the top and bottom screws of the module using a Phillips
screwdriver to secure it in place.
Step 4 Install the inter-module cables, where required.