WR3000 4-Port Wireless DSL/Cable Router
®
109
13.6.3 REMOTE MANAGEMENT: SNMP
To change your WR3000 Wireless Router’s SNMP settings, click
. The screen appears as shown.
The following table describes the labels in this screen.
which is the password for the requests from the management station.
which is the password for the requests from the management station.
which is the password for the requests from the management station.
which is the password for the requests from the management station.
which is the password for the requests from the management station.
incoming Get and GetNext.
which is the password for incoming Set requests from the
which is the password for incoming Set requests from the
If you enter a trusted host, your WR3000 Wireless Router will only respond to SNMP messages
If you enter a trusted host, your WR3000 Wireless Router will only respond to SNMP messages
from this address. A blank (default) fi eld means your WR3000 Wireless Router will respond to all
SNMP messages it receives, regardless of source.
SNMP messages it receives, regardless of source.
Type the trap community, which is the password sent with each trap to the SNMP manager.
Type the trap community, which is the password sent with each trap to the SNMP manager.
Type the IP address of the station to send your SNMP traps to.
Type the IP address of the station to send your SNMP traps to.
You may change the server port number for a service if needed, however you must use the
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the WR3000 Wireless Router
Select the interface(s) through which a computer may access the WR3000 Wireless Router
A secured client is a “trusted” computer that is allowed to communicate with the WR3000
A secured client is a “trusted” computer that is allowed to communicate with the WR3000
Wireless Router using this service.
to allow any computer to access the WR3000 Wireless Router using this service.
to just allow the computer with the IP address that you specify to access the
WR3000 Wireless Router using this service.
to save your changes back to the WR3000 Wireless Router.
to begin confi guring this screen afresh.
to begin confi guring this screen afresh.
Apply Reset
REMOTE MANAGEMENT
Service Port
161
Service Access
LAN
Secured Client IP Address
All
Selected
0.0.0.0
Get Community
Set Community
Trusted Host
Trap
Community
Destination
public
public
public
0.0.0.0
0.0.0.0
TELNET
SNMP Configuration
SNMP
FTP
WWW
SNMP
DNS
Security
