Filter
Top Products
WR3000 4-Port Wireless DSL/Cable Router
®
14
1.4.3 Connecting the WR3000 to Your Computer for Initial Confi guration
The rear panel of the WR3000 contains several ports, as described below:
For initial setup, you should have:
• The power adapter plugged into the WR3000 as shown, and this adapter plugged into a
surge-protected electrical outlet.
• Your Cable or DSL modem’s Ethernet cable plugged into the Internet In port as shown above.
• An Ethernet cable plugged into the router port 1 as shown above, and the other end of this cable
plugged into your computer’s Ethernet port.
Now proceed to the next page to begin setting up your WR3000.
Plug the AC Adapter
into this port.
Plug your computer’s Ethernet
cable into Port 1. The
remaining ports can to be used
with other computers in a hard-
wired router fashion
Plug your cable or DSL
modem’s Ethernet
Cable into this port