WR3000 4-Port Wireless DSL/Cable Router
®
155
to confi gure the LAN network for the WR3000 Wireless
to confi gure the LAN network for the WR3000 Wireless
Enter the IP address of your WR3000 Wireless Router in dotted decimal
Enter the IP address of your WR3000 Wireless Router in dotted decimal
Your WR3000 Wireless Router will automatically calculate the subnet
mask based on the IP address that you assign. Unless you are
implementing subnetting, use the subnet mask computed by the
Press [SPACE BAR] to select the RIP direction. Choices are
Press [SPACE BAR] to select the RIP direction. Choices are
Both, In Only or Out Only.
Press [SPACE BAR] to select the RIP version. Choices are
Press [SPACE BAR] to select the RIP version. Choices are
Enter the fi lter set(s) you wish to apply to the incoming traffi c between
Enter the fi lter set(s) you wish to apply to the incoming traffi c between
this node and the WR3000 Wireless Router.
Enter the fi lter set(s) you wish to apply to the outgoing traffi c between
Enter the fi lter set(s) you wish to apply to the outgoing traffi c between
this node and the WR3000 Wireless Router.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confi rm...” to save
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confi rm...” to save
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confi rm...” to save
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confi rm...” to save
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confi rm...” to save
your confi guration, or press [ESC] at any time to cancel.
Use menu 3.5 to set up your WR3000 Wireless Router as the Wireless Router. To edit menu
3.5, enter 3 from the main menu to display Menu 3 - LAN Setup. When menu 3 appears, press
5 and then press [ENTER] to display Menu 3.5 - Wireless LAN Setup as shown next.
The table on the following page describes the fi elds in this menu.
