Filter
Top Products
WAN Service Setup 40
Model 3101 Series Getting Started Guide 5 • Advanced Configuration
On the ATM PVC Configuration page, you can set the VPI and VCI values, elect the DSL latency, link type
(EoA is for PPPoE, IPoE, and Bridge.), connection mode, encapsulation mode, service category, and IP QoS
scheduler algorithm.
• VPI (Virtual Path Identifier): The virtual path between two points in an ATM network, and its valid
value is from 0 to 255.
• VCI (Virtual Channel Identifier): The virtual channel between two points in an ATM network, ranging
from 32 to 65535 (1 to 31 are reserved for known protocols).
• Select DSL Latency: You may select Path0 and Path1.
• Select DSL Link Type: You may select EoA (for PPPoE, IPoE, and Bridge), PPoA or IPoA.
• Select Connection Mode: You may select the Default Mode or the VLAN MUX Mode.
• Encapsulation Mode: You may select LLC/SNAP-BRIDGING or VC/MUX in the drop-down list.
• Service Category: You may select UBR Without PCR, UBR With PCR, UBR on Realtime VBR, or Realtime
VBR in the drop-down list.
• Select IP QoS Scheduler Algorithm: You may select Strict Priority and Weighted Fair Queuing.
Note
QoS cannot be set for CBR and Realtime VBR.
Click the Apply/Save button to enable the new settings to take effect (figure 20).
Figure 20. WMI: DSL ATM Interface Configuration
To delete an interface, select the checkbox for that interface and click Remove.
WAN Service Setup
Click Advanced Setup > WAN Service (Figure 21) to configure, modify, and remove a WAN service.
Figure 21. WMI: WAN Service Configuration
In the main WAN service list, you can click Add to configure a new WAN service, click Edit to modify an
existing WAN connection, or select the checkbox for a connection and click Remove to delete an existing
WAN connection.Refer to the following sections to configure different types of WAN connections.