Filter
Top Products
WAN Service Setup 45
Model 3101 Series Getting Started Guide 5 • Advanced Configuration
MAC Encapsulation Routing (MER) (IPoE)
To create a new MER WAN service:
1. Click Add from the main WAN service page to configure a new connection. (Before you can add a new
PPPoE service, make sure that you have created a proper ATM PVC configuration. See figure 19 on
page 39). The following page displays. Click Next to continue.
Figure 28. WMI: Select Layer2 Interface
2. On the Connection Type page (Figure 23), select the radio button for IP over Ethernet (IPoE). Click
Next to continue.
Figure 29. WMI: IPoE Connection Type
3. On the WAN IP Settings page (Figure 30 on page 46), you may may select obtain an IP address automat-
ically or manually enter the IP address provided by your ISP. If you enable IPv6 for this WAN service, you
should also enter the next-hop IPV6 address. Click Next to continue.
Note
If selecting Obtain an IP address automatically, DHCP will be
enabled for PVC in MER mode.
If selecting Use the following Static IP address, enter the WAN IP
address, subnet mask and gateway IP address.