Filter
Top Products
Wireless Security Setup 94
Model 3101 Series Getting Started Guide 6 • Wireless Configuration
WPS Setup
Figure 117. WMI: WPS Configuration
There are 2 primary methods used in the Wi-Fi Protected Setup (WPS):
• PIN entry, a mandatory method of setup for all WPS certified devices
• Push button configuration (PBC), an actual push button on the hardware or through a simulated push but-
ton in the software. (This is an optional method on wireless client).
If you are using the PIN method, you will need a Registrar (access point/wireless router) to initiate the registra-
tion between a new device and an active access point/wireless router. The PBC method may also need a Regis-
trar when used in a special case where the PIN is all zeros
In order to use the push-button for WPS authentication, you must ensure that the network card supports the
function. If it supports the WPS push-button, you do not need to configure it. Press the WPS button directly
to enable the WPS function.
Manual Setup AP
The Manual Setup AP page provides nine types of network authentication modes, including Open, Shared,
802.1X, WPA, WPA-PSK, WPA2, WPA2-PSK, Mixed WPA2/WPA, and Mixed WPA2/WPA-PSK.
Figure 118. WMI: Manual Setup AP