Filter
Top Products
Network Address Translation (NAT) Setup 65
Model 3101 Series Getting Started Guide 5 • Advanced Configuration
Click the Add button to display the Port Triggering Configuration page.
Figure 69. WMI: Adding a Port Triggering Entry
• Use interface: Select an interface that you want to configure.
• Select an application: Select a proper application in the drop-down list.
• Custom application: Manually define an application.
• Trigger port Start:The start port number that LAN uses to trigger the open port.
• Trigger port End: The end port number that LAN uses to trigger the open port.
• Trigger Protocol: Select the application protocol. You may select TCP/UDP, TCP, or UDP.
• Open Port Start: The start port number that is opened to WAN.
• Open Port End: The end port number that is opened to WAN.
• Open Protocol: Select the proper protocol that is opened to WAN. You may select TCP/UDP, TCP, or
UDP.
Click Save/Apply to apply the settings.
Note
You can use a single port number, several port numbers separated by
commas, port blocks consisting of two port numbers separated by a
dash, or any combination of these (ex: 80, 90-140, 180).