Filter
Top Products
Pelco Manual C1515M-A (11/01) 13
2. On video inputs 1 through 40, set the terminating switches according to your system
requirements. Video inputs 41 through 48 cannot be used for loop-through connections.
Terminating switches are used to terminate or unterminate the video input. The factory
default has the switches set in the terminated (75-ohm) position.
If you are connecting only a camera to an input, leave the switch in the terminated
position.
00626
Figure 5. Connecting Terminated Video Sources
If you are looping the input to another device, set the rear panel switch in the
unterminated (Hi-Z) position. Terminate at the final device.
00627
Figure 6. Connecting Looping Video Sources
NOTE:
The end point of
any video cable run must be
terminated in 75 ohms.
Installation:
Video Sources