Filter
Top Products
64 Pelco Manual C1515M-A (11/01)
SELECT CAMERAS
If you select a restricted camera view, the camera view does not appear on that monitor.
The previously selected, unrestricted camera view remains on the monitor.
KBD960/KBR960 KEYBOARDS
1. Enter the camera number.
2. Press the CAM key.
OR
Press the BWD or FWD key to scroll
through the available cameras.
OR
From the Camera Menu, select
or to scroll through the available
cameras.
KBD100/200/300 KEYBOARDS
1. Enter the camera number.
2. Press the CAM key.
OR
Press the PREV or NEXT key to scroll
through the available cameras.
CONTROL RECEIVERS
Select a suitable camera and operate a PTZ function. A keyboard with “view-only” access
can view the signal from the specified camera but cannot control the camera.
Extended Coaxitron protocol receivers can be operated without any programming changes.
Other receiver control protocols require programming changes. Refer to the
Programming
section.
Receiver control is not available with the KBD100 keyboard.
KBD200 KEYBOARD
Pan/Tilt/Zoom
Press and hold the appropriate pan/tilt key until
the camera reaches the desired position. To
change the speed of movement, press a number
(1-9) key first (1=slowest, 9=fastest).
Press and hold the appropriate zoom key until
the desired effect is seen. To change the speed
of zoom, press a number (1-4) key and then
press the WIDE key (1=slowest, 4=fastest).
Lens Control: Focus, Iris
Press and hold the appropriate
lens control key until the desired
effect is seen. To change the
speed of focus, press a number
(1-4) key, and then press the
FAR key (1=slowest, 4=fastest).
KBD300 KEYBOARD
Pan/Tilt/Zoom
Move the joystick until the camera reaches the
desired position. To increase the speed of
movement, move the joystick farther from center.
Twist the joystick clockwise to zoom in,
counterclockwise to zoom out. To change the
speed of zoom, press a number (1-4) key and
then twist the joystick (1=slowest, 4=fastest).
Lens Control: Focus, Iris
Press and hold the appropriate
lens control key until the desired
effect is seen. To change the
speed of focus, press a number
(1-4) key, and then press the
FAR key (1=slowest, 4=fastest).
Operation