Filter
Top Products
34 Pelco Manual C1515M-A (11/01)
CAMERA TITLES
By default each camera is titled “CAM #” (# = camera number from 1-48). Access the
Camera programming screen to change the camera titles.
VIDEO SOURCES
Extended Coaxitron protocol receivers can be operated without any programming changes.
For other receiver control protocols, access the Camera programming screen to select the
control type for the device connected to each video input. Control can be through standard
mode Coaxitron, extended mode Coaxitron, RS-422 PTZ through Port A or Port B on the
rear panel, or through a Genex Multiplexer.
For RS-422 PTZ control you must configure the CM6800:
• Access the Camera programming screen to identify the receiver control type
(PTZ-A or PTZ-B) and to select the appropriate camera port address. The
camera port address must match the address setting configured through the
camera/receiver DIP switch settings.
• Access the Port programming screen to select the appropriate communication
type (P or D) for serial ports 9 (PTZ-A) and 10 (PTZ-B). Default settings for PTZ-
A and PTZ-B: PTZ-P, RS-422, 4800 baud, no parity, 8 data bits, 1 stop bit.
You must also configure the camera/receiver. Refer to the appropriate camera/receiver
installation manual for configuration and address settings.
ALARMS
The CM6800 is shipped from the factory with the alarm contact enable field set to OFF. To
use the alarm features, access the Alarm programming screens to enable the alarm
contact.
COMMUNICATION PORTS
If you are using any communication port for a device not specified by the default setting,
you must access the Port programming screen to change the settings.
Table F. Default Port Settings
Port Default Settings
COM 1 MGR, RS-232, 56000 baud, no parity, 8 data bits, 1 stop bit
COM 2 ASCII, RS-232, 9600 baud, no parity, 8 data bits, 1 stop bit
COM 3 M, RS-485, 19200 baud, no parity, 8 data bits, 1 stop bit
COM 4 MUX, RS-485, 9600 baud, odd parity, 8 data bits, 1 stop bit
COM 5, 6 KBD-300, RS-485, 9600 baud, odd parity, 8 data bits, 1 stop bit
COM 7, 8 ASCII, RS-485, 9600 baud, no parity, 8 data bits, 1 stop bit
PTZ-A (Port 9) PTZ-P, RS-422, 48 baud, no parity, 8 data bits, 1 stop bit
PTZ-B (Port 10) PTZ-P, RS-422, 48 baud, no parity, 8 data bits, 1 stop bit
KBD960/KBR960 KEYBOARD
Configure the KBD960/KBR960 settings.
1. Set DIP switch 2 to the ON position.
2. Enter Setup Mode. Set the local address (1-8). (Note: the baud rate is set by default to
19200.) Each M device connected to the CM6800 must have a unique local address.
Refer to the KBD960/KBR960 Keyboard Installation/Operation Manual for detailed
setup instructions.
3. Return DIP switch 2 to the OFF position.
4. Press the EXIT icon on the keyboard LCD screen.
System
Start-Up