Filter
Top Products
58 Pelco Manual C1515M-A (11/01)
PASSWORD
Use the Set Password screen to change the system password.
If you change the password and then forget the new one, you will have to reset the system
to the factory defaults. All system programming will be lost. Pelco recommends uploading
your programming settings to the CM6800-MGR before changing the password. This allows
you to download the previous system settings, in the event of a system reset. If necessary,
refer to the
Troubleshooting
section for the system reset procedure.
Figure 46. Access the Set Password Screen
OLD PASSWORD: Enter the current password (Default: 2899100). If you make a mistake
entering the old password, the message “WRONG OLD PASSWORD.
TRY AGAIN!” appears. Re-enter the old password correctly.
NEW PASSWORD: Using the numerical keypad, enter the new password. The password
must be seven digits.
VER PASSWORD: Enter the new password again as a verification check. If you make a
mistake entering the verification password, the message “VERIFIED
PASSWORD DOESN’T MATCH” appears. Re-enter the verification
password correctly.
Once the new password is accepted, the Main Menu appears.
PELCO SWITCHER
MODEL CM6800
MAIN MENU
1 CAMERA
2 LOGICAL CAMERA
3 MONITOR
4 ACCESS
5 TIME & DATE
6 PORT
7 PRIORITY
8 SEQUENCE
9 MACRO
10 ALARM CONTACTS
11 EVENT TIMER
12 SET AUXILIARY
13 SET PASSWORD
14 ABOUT CM6800
ENGLISH
RETURN
00654
SET PASSWORD
OLD PASSWORD: *******
NEW PASSWORD: *******
VER PASSWORD: *******
RETURN
00656
Password
Programming