Filter
Top Products
56 Pelco Manual C1515M-A (11/01)
MONITOR DISPLAY
Use the Monitor screen to adjust monitor display settings for your system. You can adjust
settings for the current monitor only (CURRENT) or for all system monitors (ALL).
Figure 45. Access the Monitor Screen
MONITOR: Select CURRENT to program the monitor display for the monitor you
are currently operating or ALL for all monitors connected to the CM6800.
If you select ALL, you must navigate left or right in the SET ALL field to
apply programming changes (refer to the SET ALL field description).
CAMERA NUMBER: Enable (ON) or disable (OFF) on-screen display of the logical camera
number.
CAMERA TITLE: Enable (ON) or disable (OFF) on-screen display of the camera title
(maximum of 20 alphanumeric characters).
R/X TYPE: Enable (ON) or disable (OFF) on-screen display of the camera
control type. The letter displayed on the monitor reflects the receiver
control type selected in the CONTROL field on the Camera screen.
R/X TYPE DISPLAY VALUES:
E = Coaxitron extended mode (32-bit)
S = Coaxitron standard mode (15-bit)
M = Genex multiplexer
P = PTZ-P (RS-422 through Control Port PTZ-A or PTZ-B)
D = PTZ-D (RS-422 through Control Port PTZ-A or PTZ-B)
PELCO SWITCHER
MODEL CM6800
MAIN MENU
1 CAMERA
2 LOGICAL CAMERA
3 MONITOR
4 ACCESS
5 TIME & DATE
6 PORT
7 PRIORITY
8 SEQUENCE
9 MACRO
10 ALARM CONTACTS
11 EVENT TIMER
12 SET AUXILIARY
13 SET PASSWORD
14 ABOUT CM6800
ENGLISH
RETURN
00654
MONITOR CURRENT
CAMERA NUMBER: ON
CAMERA TITLE: ON
R/X TYPE: ON
MON/ALM NUMBER: ON
MON/ALM STATUS: ON
TIME: ON
DATE: ON
BRIGHTNESS 8
POSITION DISPLAY
SET ALL
RETURN
00655
00620
00620
00620
Monitor
Programming