Filter
Top Products
Pelco Manual C1515M-A (11/01) 63
OPERATION
OVERVIEW
A brief description of CM6800 operation is provided here. Refer to the following sections for
detailed instructions and options.
Install the CM6800 and
connect all system devices.
Power-up the system.
Switch monitor.
Select camera.
Control PTZ receivers.
Call a preset.
System does not function.
Refer to the
Installation
section.
Refer to the
System Start-up
section.
1. Enter the monitor number.
2. Press the MON key.
1. Enter the camera number.
2. Press the CAM key.
Use the appropriate PTZ control keys or joystick
(depending on the keyboard used).
Extended Coaxitron protocol receivers can be operated
without any programming changes. Other receiver
control protocols require programming changes.
Program the preset through the keyboard.
1. Enter the preset number.
2. Press the PRESET key or Prst/Lock key
(depending on the keyboard used).
Refer to the
Troubleshooting
section.
OPERATING THE CM6800
The CM6800 can be operated with a KBD100, KBD200, KBD300, KBD960, or KBR960
keyboard. Operation instructions are provided below, but you should become familiar with
the detailed instructions provided in the appropriate keyboard manual.
The CM6800 can also be controlled with ASCII commands. Refer to the
ASCII Operating
Commands
section.
SWITCH MONITORS
If you select a restricted monitor, the monitor does not switch; the keyboard LED displays
the previously selected monitor number.
ALL KEYBOARDS
1. Enter the monitor number.
2. Press the MON key. The keyboard LED displays the selected monitor number.
Operation