Filter
Top Products
Pelco Manual C1515M-A (11/01) 75
Desired Action
Select monitor
Select camera
Next camera
Previous camera
Start a sequence forward
Start a sequence backward
Hold a sequence
Hold a macro
Pan left
Pan right
Stop pan left
Stop pan right
Tilt up
Tilt down
Stop tilt up
Stop tilt down
Zoom telephoto
Zoom wide
Stop zoom telephoto
Stop zoom wide
Focus near
Focus far
Stop focus near
Stop focus far
Iris open
Iris close
Stop iris open
Stop iris close
Stop all PTZ motion
Record pattern
Execute pattern
End pattern
Go to preset position
Set preset with a label
Set preset without a label
Begin zone
Begin zone with a label
End zone
Begin random scan
Begin frame scan
Stop scan
Command
[1-9999]Ma
[1-9999]#a
+a
-a
[1-99]qa
[1-99]ba
ea
[1-32]ea
[1-64]La
[1-64]Ra
~La
~Ra
[1-63]Ua
[1-63]Da
~Ua
~Da
Ta
Wa
~Ta
~Wa
Na
Fa
~Na
~Fa
Oa
Ca
~Oa
~Ca
sa
[1-99]/a
[1-99]pa
[1-99]na
[1-99]\a
la[string]!a
[1-9999]^a
[1-9999]-^a
[1-8](
la[string]!a[1-8](
[1-8])
1@
2@
~@
Result
Calls a monitor to use for camera operation.
Selects a camera to display on the current operating monitor. The
NEXT key (+) and PREV key (-) commands switch to the next
numbered camera in the system.
Starts the selected sequence going forward (incrementing camera
numbers).
Starts the selected sequence going backward (decrementing camera
numbers).
Places the running sequence on hold, freezing the currently selected
camera on the monitor. It lets you control the camera or switch. The
sequence is still “armed” on the monitor, but inactive.
Places the running macro on hold.
Moves the currently selected pan and tilt device left or right at the speed
indicated. If you omit the speed, some devices move at their default
speed and others move at their slowest possible speed. Speed
information has no effect on fixed speed devices.
Moves the currently selected pan and tilt device up or down at the
speed indicated. If you omit the speed, some devices move at their
default speed and others move at their slowest possible speed. Speed
information has no effect on fixed speed devices.
Makes the currently selected camera zoom in (close up view) or zoom
out (wide view).
Changes the good focus range nearer or farther on the currently
selected camera.
Opens (brighter image) or closes (darker image) the iris on the
currently selected camera.
Stops all image motion (stops pan, tilt, zoom, focus, and iris). Does not
stop a pattern.
On receivers that do patterns, these commands let you record your
motions and operations (for a limited time) and then have the system
repeat them.
Recalls a stored preset position.
Sets a preset location with an embedded label, where the ASCII string
must be UPPERCASE characters.
The [string] is an alphanumeric label up to 20 characters long and
[1-9999] is the associated preset number.
NOTE: All transmitted characters must be ASCII.
Sets a preset location without an embedded label.
Begins a zone without a label.
Begins a zone with an embedded label. The ASCII string must be
uppercase characters.
Ends the zone program
These commands start and stop scans.
Table J. ASCII Commands
Number ranges are enclosed in brackets – do not enter the brackets. When you control a fixed speed pan and tilt, omit the speed
information.
(Continued on next page)
Appendix