Filter
Top Products
18 Philips · LaserMFD 6170dw
EN
5 At the conclusion of the install process you must
restart your computer. Make your selection as to
whether the computer should restart automatically
or whether you would like to restart the computer
yourself at a later time.
6Only after the restart, connect the device to your
PC with a typical USB cable. The USB port of your
device can be found on the rear side.
7 Your device is detected as a new peripheral device
and registered.
8 If your operating system is Windows XP (Service
Pack 2), an additional window will appear during the
final installation. Select No, not this time, and click
on Next.
9 Under Windows XP, select Install software auto-
matically during the final installation and click on
Next.
Notice
Only high-speed certified USB cable
Use only a custom high speed certified
USB cable to connect the device to your
computer. The cable should be no longer
than 1.5 metres.