Filter
Top Products
9-4 SV61162 Rev. C
9 • Maintaining and Updating
Tape Has Run Out
1. If the system actually runs out of tape, the “Out of Tape” screen ap-
pears.
2. Open the cover and select Unload Tape on the “Out of Tape” screen.
3. Remove the empty tape roll. Follow steps 2 - 4 in the Tape Still on Roll
procedure above.
3. Drop the new tape in so
that it feeds from the
bottom of the roll to the
right.
The protective backing on
the tape should be facing
down.
Pull about 10 inches of
tape from the end of the
roll up toward the cover
and then loop it down into
the slot.
CAUTION: Do not load a tape strip that has any pink or black
stripes showing. This will cause the last piece of tape to jam in
the machine which and you will need to place a service call.
4. From the “Out of Tape” or "Load Tape" screen, select Load Tape. Feed
the tape into the slot while the tape motor is running. The machine au
-
tomatically cuts off the excess tape.
5. Close the feed cover.