Filter
Top Products
SV61162 Rev. C 4-17
DM800™ Series Digital Mailing System Operating Guide
Mode Selection: Seal Only
Use this mode if you just want to seal the envelopes and do not want to
apply postage.
1. Press the
Mode key.
2. Select
Seal Menu - No Printing and select the appropriate option.
3. Select the
Reset Counter option if you want to clear the number of
pieces of mail fed into the machine in the seal only mode.
4. Place the mail on the feed deck.
5. Press the
Start key.
NOTE: For additional sealing options, press the Seal key on the
IntelliLink® Control Center. This allows you to select the following options:
• Sealer on (seal envelopes)
• Sealer off
• Seal only, don’t print
• Adjust Wetness*
• Prime Moistener*
*For more information, refer to the Adjusting the Wetness and Priming the
Moistener sections in Chapter 9 of this guide.
6. If you are using the optional DJPS/DMPS Power Stacker, we recom-
mend you remove your mail in manageable stacks and not allow the
deck to fill completely. The system will halt the stacker if it is filled to its
maximum capacity.
To select a Print Permit:
1. From the IntelliLink® Control Center, press the Mode key.
2. Select
Print Permit. The “Print Permit Selection” screen appears.
3. Select the permit you want and press
Enter.
4. Place the mail on the feed deck.
5. Press the
Start key.
6. If you are using the optional DJPS/DMPS Power Stacker, we recom
-
mend you remove your mail in manageable stacks and not allow the
deck to fill completely. The system will halt the stacker if it is filled to its
maximum capacity.