Filter
Top Products
SV61162 Rev. C 9-7
DM800™ Series Digital Mailing System Operating Guide
Cleaning or Replacing the Wick
1. Open the feed cover and lift the E-Z Seal® Sealing
Solution bottle out of its holder.
2. Remove the Moistener Brush Assembly as described in the
Cleaning
or Replacing the Moistener Brush procedure.
3. Use your index and middle finger to remove the wick.
Wick
4. Clean the moistening brush by
running the brush under warm
water.
5. If you need to clean or replace
the wick, go to Cleaning or
Replacing the Wick
procedure
below. Otherwise go to step 6.
6. Replace the existing clean
moistener brush assembly, or
install a new one by pushing
the assembly back on its track
until it snaps into position.
7. Verify that the moistener brush
assembly is perfectly level with
the feed deck.
Moistener brush
Clean here
to ensure it is
free of dirt and
grime
Moistener
Maintenance
continued
4. Clean the wick by holding it under running water.
5. Slide the wick back into place.
6. Replace the E-Z Seal® bottle.