A – Command Line Interface
Set Command
A-30 59048-02 A
Q
Set Command
Sets a variety of switch parameters.
Authority Admin for all keywords except Alarm Clear, Beacon, and Pagebreak which are
available with User authority.
Syntax set
alarm clear
beacon [state]
blade [slot_number] [state]
config [option]
log [option]
pagebreak [state]
port [option]
setup [option]
switch [state]
Keywords alarm clear
Clears the alarm log. This keyword is available with User authority.
beacon [state]
Enables or disables the flashing of the Port Status LEDs according to [state]. This
keyword is available with User authority. [state] can be one of the following:
on
Enables the flashing beacon.
off
Disables the flashing beacon.
blade [slot_number] [state]
Temporarily changes the administrative state given by [state] for all ports on the I/
O or cross-connect blade occupying the slot given by [slot_number]. The previous
Set Config Switch settings are restored after a switch reset or a reactivation of a
switch configuration. [slot_number] is a number in the ranges 1–4 and 6–9. [state]
can be one of the following:
online
Places the I/O blade and its ports online.
offline
Places the I/O blade and its ports offline.
diagnostics
Prepares the I/O blade and its ports for testing.
down
Disables the I/O blade and its ports.
config [option]
Sets switch, blade, port, alarm threshold, and zoning configuration parameters.
Refer to the ”Set Config Command” on page A-32.