A – Command Line Interface
Set Config Command
59048-02 A A-35
Q
switch
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Table A-10. Set Config Switch Parameters
Parameter Description
AdminState Switch administrative state: online, offline,
or diagnostics. The default is Online.
BroadcastEnabled Broadcast. Enables (True) or disables
(False) forwarding of broadcast frames.
The default is True.
InbandEnabled Inband management. Enables (True) or
disables (False) the ability to manage the
switch over an ISL. The default is True.
DefaultDomainID Default domain ID. The default is 1.
DomainIDLock Prevents (True) or allows (False) dynamic
reassignment of the domain ID. The
default is False.
SymbolicName Descriptive name. The default is
SANbox2.
R_A_TOV Resource Allocation Timeout Value. The
number of milliseconds the switch waits to
allow two ports to allocate enough
resources to establish a link. The default is
10000.
E_D_TOV Error Detect Timeout Value. The number
of milliseconds a port is to wait for errors to
clear. The default is 2000.
PrincipalPriority The priority used in the FC-SW-2 principal
switch selection algorithm. 1 is high, 255 is
low. The default is 254.
ConfigDescription The name for the configuration. The
default is undefined.