A – Command Line Interface
Set Setup Command
A-48 59048-02 A
Q
Examples The following is an example of the Set Setup SNMP command:
SANbox2 #> admin start
SANbox2 (admin) #> set setup snmp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Trap Severity Options
---------------------
unknown, emergency, alert, critical, error, warning, notify, info, debug, mark
Contact (string, max=32 chars) [<sysContact undefined]
Location (string, max=32 chars) [sysLocation undefined]
Trap1Address (dot-notated IP Address) [10.20.71.15 ]
Trap1Port (decimal value) [162 ]
Trap1Severity (see allowed options above) [warning ]
Trap1Version (1 / 2) [2 ]
Trap1Enabled (True / False) [False ]
Trap2Address (dot-notated IP Address) [0.0.0.0 ]
Trap2Port (decimal value) [162 ]
Trap2Severity (see allowed options above) [warning ]
Trap2Version (1 / 2) [2 ]
AdminTimeout Specifies the amount of time in minutes the switch
waits before terminating an idle Admin session. Zero
(0) disables the time out threshold. The default is 30,
the maximum is 1440.
SecurityEnabled Enables (True) or disables (False) the enforcement of
account names and passwords. The default is False.
LocalLogEnabled Enables (True) or disables (False) the saving of log
information on the switch. The default is True.
RemoteLogEnabled Enables (True) or disables (False) the recording of
the switch event log on a remote host that supports
the syslog protocol. The default is False.
RemoteLogHostAddress The IP address of the host that will receive the switch
event log information if remote logging is enabled.
The default is 10.0.0.254.
Table A-14. System Configuration Settings (Continued)
Entry Description